Black and Decker CYCLONIC POWER PRO VCBD2050-AR Instrucciones página 11

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

5. To remove extension tubes, just pull out the ends of each tube.
HOW TO USE
This appliance is intended for household use. It is for indoor use only.
Important: The power cord has a yellow marking and a red marking to help you determine the maximum length
to use. Up to the yellow marking is the recommended length. Never pull cord beyond the red marking.
This vacuum cleaner is equipped with an overheat protection system. If for some reason your vacuum overheats,
the motor will turn off
Allow the motor to cool for a minimum of 15 minutes prior to re-starting the unit.
To prevent overheating make sure that the lters and the dust bin are clean.
6. Holding the power cord by the plug, pull out the required length and plug into a standard electric outlet.
7. Press the On/Off push button
8. Press variable speed control to desired setting
9. Adjust the suction power by sliding the vacuum suction control on the hose.
10.
11. As you vacuum, check the removable plastic dust collector frequently; when the dust collector is full
empty it. To empty the dust collector, see Dust Collect or in the Care and Cleaning section.
12.
13. Unplug unit.
14. Press the retractable cord push button
Caution:
• The cord moves fast when retracting. Stand clear of the cord as it rewinds so it does not swing into you.
• To prevent cord from whipping when rewinding, hold plug when rewinding onto cord reel.
USING CLEANING TOOLS
CREVICE TOOL
• Use crevice tool for tight narrow spaces.
Tip: You can keep the crevice tool and the upholstery brush on the storage clip that is mounted on the extension tube.
VACUUM ACCESORIES
CREVICE TOOL WITH BRUSH: use to clean edges, corners, and sides of upholstery.
2 EXTENCION TUBES:
FLEXIBLE SWIVEL HOSE:
COMBINATION FLOOR BRUSH: use to vacuum grime on all surfaces.
UPHOLSTERY NOZZLE: use to vacuum upholstery.
CARE AND CLEANING
Important: Always turn off and unplug the unit before cleaning any parts.
CLEANING
Note:
To maintain maximum cleaning performance, empty the dust collector when is at max level, and clean
DUST COLLECTOR
15. To remove dust collector, press release button on the handle and lift up.
16. Press and release button on the dust collector to open the lid and empty the dust collector.
17. Wash in warm sudsy water with mild detergent.
18. Dry the dust collector completely with a soft cloth before reinstalling.
. Should this occur, turn the switch off and unplug the vacuum from the wall outlet.
to start the vacuum cleaner.
. The cord winds back into the unit.
11
Tabla de contenido
loading

Tabla de contenido