Making Settings - Grohe Eurosmart Cosmopolitan E 36 315 Manual Del Usaurio

Ocultar thumbs Ver también para Eurosmart Cosmopolitan E 36 315:
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 16

Making settings

The infrared electronics provide seven preset programmes for selection. Programme 1 is set at the factory.
Programme
Temporary
shutoff*
Programme 1
Active
Programme 2
Active
Programme 3
Active
Programme 4
Active
Programme 5
Active
Programme 6
Inactive
Programme 7
Inactive
* Cleaning mode can be activated when temporary shutoff is activated. In cleaning mode, water flow is not started for
3 minutes even if an object is detected.
** Automatic flushing serves to ensure water hygiene in the event of long-term non-utilisation of the fitting. Flushing is initiated
for a duration of 1, 5 or 10 minutes after 24 hours (usage-independent) or 72 hours after the fitting was last used
(usage-dependent).
Safety note:
Ensure free draining in the case of activated automatic flushing.
The fitting can be individually programmed using the remote control (see Special accessories, Prod. no.: 36 206).
Selecting a programme
The programme is selected via the infrared sensor system.
1. Activate setting mode:
Loosen screw (G1) and remove wall plate (G), see Fig. [10].
Disconnect the power supply to the electronics and
reconnect after 10 s, see Fig. [11]. Setting mode is active
for 3 minutes.
2. Hold finger against the lower area of the sensor system,
see Fig. [12].
The indicator lamp (P) in the sensor system flashes quickly.
3. Remove finger from the sensor system once the indictor
lamp goes out. Programme selection mode is activated.
4. Hold finger against the lower area of the sensor system
again.
The programmes are displayed by groups of flashing signals
via the indicator lamp. The groups are separated by a
pause.
5. Programmes and display:
Display starts with the programme that is currently set. The
number of flashing signals corresponds to the individual
programmes:
1 = Programme 1
Pause
2 = Programme 2
Pause
...
For latest prices and delivery to your door visit MyTub Ltd - 0845 303 8383 - www.mytub.co.uk - [email protected]
Automatic flushing**
On/off
Flush interval Flush duration
Off
-
-
On
72 h
5 min
On
24 h
5 min
On
72 h
10 min
On
72 h
1 min
Off
-
-
On
72 h
5 min
7 = Programme 7
Pause
After the group with 7 flashing signals, the routine starts
from the beginning.
1 = Programme 1
...
6. Selecting a programme:
The programme is selected by removing the finger from the
sensor system during the pause after the required
programme. The corresponding flashing signals are
displayed again after the finger is removed.
7. A new programme can be selected within the next 5 s if
required. Programme selection mode is automatically
terminated if the finger is removed from the sensor system
before 5 s have elapsed.
Duration of
thermal
disinfection
Usage-dependent/
independent
-
3.5 min
Usage-dependent
3.5 min
Usage-independent
11 min
Usage-dependent
3.5 min
Usage-dependent
3.5 min
-
3.5 min
Usage-dependent
3.5 min
6
Tabla de contenido
loading

Tabla de contenido