Fuse Replacement; Troubleshooting - AquaPRO 54064-0 Manual Del Propietário

Fuse Replacement

1. Gently press the two fuse holders and turn the fuse holder counterclockwise to release them.
2. Push the new fuse firmly up into the fuse holder.
3. Gently press the two fuse holders and turn the fuse holder clockwise to reassemble.

TROUBLESHOOTING

Problem
The pump stops without
warning.
The pump does not prime.
The pump leaks.
The pump runs but pumps little
or no water.
Possible Cause
1. The cord set is loose.
2. The fuse is blown.
3. The battery has no charge.
1. The impeller is worn.
2. The suction is leaking.
3. The suction hose is kinked or coiled.
1. The shaft seal is leaking.
2. The cover O-ring is leaking.
1. The impeller is worn.
2. The suction or discharge hose is
kinked or coiled.
6
Item Description
1 O-ring
2 Impeller
3 Impeller Cover
4 Screw
Corrective Action
1. Reconnect the cord set.
2. Replace the fuse.
3. Recharge the battery or
replace with a new battery.
1. Replace the impeller.
2. Replace the hose washer and
check for leaks in the hose.
3. Straighten out the suction
hose.
1. Replace the pump.
2. Reassemble the cover O-ring.
1. Replace the impeller.
2. Straighten out the hose.
Qty.
1
1
1
6