Replacing Components; Cleaning The Interior; Main Components - Virtus 70/40 BMG Serie Instalación, Uso, Mantenimiento

HEATING CANNOT BE ADJUSTED.
Possible causes:
- Temperature thermostat defective.

19. REPLACING COMPONENTS

REMINDERS FOR REPLACING COMPONENTS
SHUT THE GAS SHUT-OFF VALVE
AND/OR SWITCH THE APPLIANCE OFF
AT THE MAIN SWITCH INSTALLED
UPSTREAM.
AFTER REPLACING A GAS SYSTEM
COMPONENT, CHECK FOR GAS LEAKS
AT CONNECTION POINTS.
DISCONNECT THE APPLIANCE ELECTRIC
SUPPLY, IF PRESENT, BEFORE CARRYING
OUT ANY OPERATION.
AFTER REPLACING AN ELECTRICAL
SYSTEM COMPONENT, CHECK IT IS
CORRECTLY WIRED.
GAS BAIN MARIE
REPLACING THE GAS VALVE AND PIEZO IGNITER.
- Remove the control panel.
- Remove the bulb from its seat on the well.
- Remove and replace the component.
- Reassemble all parts. For assembly, proceed in
reverse order.
REPLACING THE MAIN BURNER, PILOT BURNER,
THERMOCOUPLE AND IGNITER.
- Remove the control panel.
- Remove the entire gas assembly (cock, gas pipe,
main and pilot burner, front combustion chamber
wall).
- Remove and replace the component.
- Reassemble all parts. For assembly, proceed in
reverse order.
ELECTRIC BAIN MARIE
REPLACING THE HEATING AND LIGHT GLOWS.
- Remove the control panel.
- Remove and replace the component.
- Reassemble all parts. For assembly, proceed in
reverse order.
REPLACING THE WORKING THERMOSTAT AND
SAFETY THERMOSTAT
- Remove the control panel.
- Remove the bulb from its seat on the well.
- Remove and replace the component.
- Reassemble all parts. For assembly, proceed in
reverse order.
POTATO WARMER
REPLACING THE INFRARED HEATING ELEMENT
- Remove the healting support.
- Remove and replace the component.
- Reassemble all parts. For assembly, proceed in
reverse order.
REPLACING THE HEATING ELEMENT
- Pull out the control knobs, remove control panel
and the container.
- Disconnect the faulty heating element, remove
and replace it. Have care to fit in right position the
fixing flange seal (better replace it).

20. CLEANING THE INTERIOR

- Check the condition of the inside of the appliance.
- Remove any built-up dirt.
- Check and clean the fumes exhaust system.

21. MAIN COMPONENTS

GAS BAIN MARIE
- GAS COCK
- MAIN BURNER
- Pilot burner
- Thermocouple
- Igniter
- Piezoelectric ignition
25