Using The Gas Bain Marie - Virtus 70/40 BMG Serie Instalación, Uso, Mantenimiento

Do not leave the appliance unattended while in
operation.
In the event of an appliance fault or malfunction,
shut the gas shut-off valve and/or switch the
appliance off at the main switch installed upline.
Clean the appliance following the instructions
given in Chapter " INSTRUCTIONS FOR CLEANING".
DO NOT STORE " AMMABLE
MATERIALS IN CLOSE PROXIMITY TO
THE APPLIANCE. FIRE HAZARD.
Do not obstruct any air vents or drains present on
the appliance.
Do not tamper with appliance components.
Keep this manual in a safe place, known to all
users, so that it can be consulted throughout the
working life of the appliance.
Installation and appliance maintenance must be
carried out by qualified technicians authorized by
the manufacturer, in compliance with current
safety standards and the instructions in this
manual.
Appliance maintenance and conversion to a
different type of gas must be carried out by
qualified technicians authorized by the
manufacturer, in compliance with current safety
standards and the instructions in this manual.

11. USING THE GAS BAIN MARIE

The appliance is designed for indirect cooking of
foods in cooking receptacles and for keeping food
warm in a bain marie.
Do not light the pilot burner or leave it on when
there is no water in the well.
Do not activate the heating system when there is
no water in the well.
While the appliance is on, the water level must be
maintained level with or above the minimum level
indicated on the wall of the well.
At the end of each day, clean the well thoroughly
in order to prevent the formation of corrosive
deposits.
FILLING AND EMPTYING OF THE TANK
FILLING
Insert the overflow pipe in the drain hole of the
well.
Fill the tank up to the maximum level mark this on
the wall of the tank.
Do not use the equipment with a water level
higher than the maximum level mark.
EMPTYING
Remove the overflow pipe from the drain hole of
the well.
BURNER IGNITION AND EXTINCTION
The gas tap control knob has the following
positions:
OFF
PILOT IGNITION
MAXIMUM WATER TEMPERATURE
INTERMEDIATE TEMPERATURES
MINIMUM TEMPERATURE
PILOT IGNITION
- Press and turn knob to "pilot on".
- Press the knob down fully and light the pilot using
the piezoelectric igniter.
- Hold the knob down for about 20 seconds before
releasing it. If the pilot flame goes out, repeat the
operation.
- The pilot " ame can be seen through the peep
hole on the control panel.
- The pilot burner can be lit by passing a flame
through the bullseye on the bottom of the
appliance.
MAIN BURNER IGNITION
- Turn the knob to the chosen temperature setting
for cooking.
21