Ek 100 G2 Bodypack Receiver - Sennheiser evolution wireless Serie Instrucciones Para El Uso

EK 100 G2 bodypack receiver

Inserting and replacing the batteries
For powering the EK 100 G2 bodypack receiver, you can either use two 1.5 V
AA size batteries or the rechargeable Sennheiser BA 2015 accupack.
Press the two unlocking buttons
cover .
Insert the two batteries or the BA 2015 accupack as shown in the diagram
on the left. Please observe correct polarity when inserting the batteries/
accupack.
Close the battery compartment. The battery compartment cover
into place and clicks.
Note:
For accupack operation of the receiver, only use the BA 2015 accupack In
order to ensure optimum operational reliability. For charging the
accupack, only use the L 2015 charger. Both the accupack and the charger
are available as accessories.
The accupack is fitted with an integrated sensor which is – via a third
contact – monitored by the electronics of the receiver and the charger.
The sensor is necessary for the following control purposes:
The taking into account of the different voltage characteristics of
primary cells (batteries) and accupacks. The battery status indications
on the displays, the transmission of transmitter battery status
information to the rack-mount receivers and the switch-off thresholds
at the end of the operating time are corrected correspondingly. Due to
the missing sensor, individual rechargeable battery cells will not be
identified as accupacks.
The monitoring of the accupack temperature during charging in the
L 2015 charger.
The prevention of improper charging of inserted primary cells
(batteries). Due to the missing sensor, individual rechargeable battery
cells will also not be charged in the L 2015 charger.
Connecting units to the audio output
You can connect a PA system or a recording unit (e.g. video camera) to the
EK 100 G2 bodypack receiver.
Connect one of the supplied line output cables to the recording unit.
Connect the 3.5 mm jack plug to the audio output (AF OUT)
Lock the 3.5 mm jack plug by screwing down the coupling ring.
Via the operating menu, adapt the level of the audio output (AF OUT) to
the input sensitivity of the connected unit (see: „Adjusting the audio out-
put level (receivers only)" on page 33).
and open the battery compartment
.
locks
17