Rear Panel; System Requirements; Installation Environment; Hardware Installation Steps - Abit 5001 Manual Del Usuario

2.1.2 Rear panel

2.2 System Requirements

 Broadband Internet Access Service (DSL/Cable/Ethernet)
 One DSL/Cable modem that has an RJ45 connector (you do not need it if you connect the router
to Ethernet)
 Each PC on the LAN needs a working Ethernet Adapter and an Ethernet cable with RJ45
connectors
 TCP/IP protocol must be installed on each PC
 Web browser, such as Microsoft IE 5.0 or later, Netscape Navigator 6.0 or later

2.3 Installation Environment


Not in direct sunlight or near a heater or heating vent
 Not cluttered or crowded. There should be at least 2 inches (5cm) of clear space on all sides of
the router
 Well ventilated (especially if it is in a closet)
 Operating temperature: 0℃~40℃
 Operating Humidity: 5%~90%RH, Non-condensing

2.4 Hardware Installation Steps

Before you install the router, you should connect your PC to the Internet through your broadband
service successfully. If there is any problem, please contact your ISP. After that, please install the router
according to the following steps. Don't forget to pull out the power plug and keep your hands dry.

Power off your PC(s), Cable/DSL modem, and the router.

Locate an optimum location for the router. The best place is usually near the center of the area in
which your PC(s) will wirelessly connect. The place must accord with the Installation Environment
Requirements.
 Adjust the direction of the antenna. Normally, upright is a good direction.
 Connect the PC(s) and each Switch/Hub on your LAN to the LAN Ports on the router.
 Connect the DSL/Cable Modem to the WAN port on the router.
 Connect the AC power adapter to the AC power socket on the router, and the other end into an
electrical outlet. The router will start to work automatically.

Power on your PC(s) and Cable/DSL modem.
8