Tcp/Ip Setting; Lan Status - Abit 5001 Manual Del Usuario

WPS: To enable or disable WPS function. The default is "disable".
Self-PIN Number: The effective key generated by AP automatically.
Push-Button Configuration: Provide two ways: PBC (Push-Button Configuration) and PIN code.
PBC: Select the PBC or press the RST/WPS button on the front panel of the device for about one
second (Press the button for about one second and WPS indicator will be blinking for 2 minutes, which
means the WPS is enabled. During the blinking time, you can enable another device to implement the
WPS/PBC negotiation between them. Two minutes later, the WPS indicator will be off, which means the
WPS connection is completed. If more clients are added, repeat the above steps.
Client PIN Number: If this option is enabled, you need to enter a wireless client's PIN code in the field
and keep the same code in the WPS client.

4.3 TCP/IP Setting

4.3.1 LAN Status

This page shows the current status and some basic settings of the device. you can check system
Information, LAN Interface Information
MAC Address: The physical address of the router, as seen from the LAN. The value can't
be changed.
IP Address: Enter the IP address of your router in dotted-decimal notation (factory default:
192.168.1.1).
Subnet Mask: An address code that determines the size of the network. Normally use
255.255.255.0 as the subnet mask.
DHCP: You can select None, Client, Serve. The router is set up by default as a DHCP (Dynamic Host
Configuration Protocol) server, which provides the TCP/IP configuration for all the PCs that are
24