Operation Mode - Abit 5001 Manual Del Usuario

The default is TKIP mode
WPA2-PSK: WPA2-PSK (Wi-Fi Protected Access Version 2) provides higher security than WEP
(Wireless Equivalent Privacy) and WPA (Wi-Fi Protected Access)

3.3 Operation Mode

Gateway (Default) In this mode, the device is supposed to connect to internet via ADSL/Cable
Modem. The NAT is enabled and PCs in LAN ports share the same IP to ISP through WAN port. The
connection type can be setup in WAN page by using PPPOE, DHCP client, PPTP client or static IP.
Bridge: In this mode, all Ethernet ports and wireless interface are bridged together and NAT function
is disabled. All the WAN related function and firewall are not supported.
Wireless ISP: In this mode, all Ethernet ports are bridged together and the wireless client will
connect to ISP access point. The NAT is enabled and PCs in Ethernet ports share the same IP to ISP
through wireless LAN. You must set the wireless to client mode first and connect to the ISP AP in
Site-Survey page. The connection type can be setup in WAN page by using PPPOE, DHCP client,
PPTP client, L2TP client or static IP.
17