Tabla de contenido
Idiomas disponibles
Idiomas disponibles
YOUR AIR PURIFIER
HPA060 Series
Type
Control Panel
HPA160 Series
Control Panel
Type
2
True HEPA
Type
Household Gas
Filter (1)
& Odor Reducing Pre-filter
True HEPA
Type
Household Gas
Filters (2)
& Odor Reducing Pre-filter
HOW YOUR AIR PURIFIER WORKS
This model air purifier incorporates a 2-stage cleaning
system to help clean the air that passes through the filter
in the unit (Fig. 1).
Rear
Grille
Stage 1: Household Gas & Odor Reducing Pre-Filter
Stage 2: True HEPA Filter that captures particles
as small as 0.3 microns or larger
SET-UP
• Select a firm, level and flat location.For best airflow, locate the unit so it is not directly up against the
wall or against any furniture. This will enhance performance.
• When operating, large volumes of air are drawn toward the air purifier. Surrounding areas should be
cleaned and/or vacuumed frequently to prevent build-up of dust and other contaminates. This may
also help prolong the life of the filter. If the unit is placed on a light colored carpet, a small mat or rug
should be used underneath to prevent permanent staining. This is especially important in homes with
contamination from smoking, fireplaces, or where candles are burned.
• Ensure the front of the unit faces away from the closest wall or furniture.
• Ensure no grilles are blocked.
INSTALL TRUE HEPA FILTERS AND ODOR REDUCING PRE-FILTER
Rear
Grille
The True-HEPA Filters are supplied within the air purifier. They are wrapped to
ensure purity, and are labeled to help identify the proper replacement filter.
• Before using your new air purifier you must remove the wrapper covering the
filter(s). Make sure the air purifier is OFF and unplugged. While pressing on the
tab at the top of the rear grille, pull the grille towards you and remove it from the
unit and set it aside (See Fig. 2). Grasp the sides of each filter frame near its top
end and pull outward. Repeat for the second filter if applicable.
• Remove protective wrap from the filter(s).
• Place the HEPA filter(s) into the air purifier housing with the arrows pointing
toward the unit. Insert the bottom edge of the filter frame and press the top of
the filter down and inward until the filter is firmly in place. Repeat for the second
filter if applicable.
Install the Household Gas & Odor Reducing Pre-Filter that is supplied within the air purifier. It will be
wrapped in plastic wrap to keep it fresh
• Remove the pre-filter from the protective plastic bag.
• Secure the pre-filter under the pre-filter clips on the inside of the rear grille.
• Replace the rear grille by lining up the tab at the bottom of the grille with the slot in the air purifier.
Push the top of the grille towards the unit until it snaps in place. Snap the filter grille back into place.
Fig. 1
2
STAGE 1
Odor Reducing
Pre-Filter
.
(Type
)
.
(Type
)
STAGE 2
Filter(s)
Fig. 2
3
Tabla de contenido
