Installation - FAS International SPIRALI HDR Manual Del Usuario

Spirali HDR Panzer - Issue 00
Once the vending machine has been unpacked, it can be set at work following the instructions below:
The appliance is not suitable for external installation as it must not be exposed to
direct sunlight or be installed where water jets may be used. The appliance is suitable
for installation in locations where the ambient temperature ranges between 3°C and
32°C.
1) Ensure that the main switch is in the "OFF" (O) position and that the fuses are securely in place.
2) The equipment must be supplied with single-phase voltage 230V 50Hz with the general switch off.
The appliance must be connected to a power supply mains featuring earthing which
complies with current legislation. The manufacturer recommends providing an electric
power supply mains for the vending machine which is equipped with a disconnecting
device having a contact opening of at least 3 mm. Ensure that the plug is accessible
after installation. It is strictly forbidden to use extension cords, adaptors or multiple
jacks.
As the colour of the wires in the cable of this equipment may not correspond to the
colour marking in the terminals of your socket, proceed as follows:-
The GREEN and YELLOW wire must be connected to the socket terminal marked
with the letter E or with the GREEN or GREEN and YELLOW earth symbol. The BLUE
wire must be connected to the socket terminal market with the letter N or coloured
BLACK or BLUE. The BROWN wire must be connected to the socket terminal marked
with the letter L or coloured RED or BROWN.
The manufacturer cannot be held responsible for damages caused by the failure
to observe the precautions given above.
3) After having positioned the machine, adjust the four adjustable feet so that the machine is perfectly
horizontal; all the feet must be in contact with the floor.
4) To ensure adequate air circulation of the refrigeration unit, install the conveyor supplied with the machine
following the instructions given on the conveyor itself.
Check that the grids behind and under the refrigeration unit are kept clean and unobstructed.
It is not recommended to install the covers of the front legs in environments where the ambient
temperature exceeds 30°C.
Failure to install or incorrect installation of the rear conveyor annuls the guarantee.
If the machine is to be fitted into a wooden
cabinet or similar housing, ensure that the
grills and the lower sides of the machine are
kept clear for ensuring adequate air circulation.
FAS INTERNATIONAL S.p.A. Via Lago di Vico, 60 SCHIO (VI) – tel. +39 0445 502011 – fax +39 0445 502010 - e-mail: [email protected]
7

INSTALLATION

The following instructions are valid only to the United Kingdom
The wires in the cable are coloured coded as follows:
GREEN AND YELLOW - EARTH ---- BLUE - NEUTRAL ---- BROWN - LIVE
WALL FIXING BRACKETS:
Fix the brackets above the V.M. by means of the
screws provided in the kit. Fix them to the wall by
making a suitable hole.
11
E
N
G
L
I
S
H