DermLite DL1 basic Manual De Instrucciones página 3

the unit to activate the light and place the DL1 with
its glass faceplate (F) directly onto the skin. Use
your mobile device's camera function or any avail-
able camera app (including any "DermLite" brand
app) to take a photo. To turn off your DL1, simply
push the power button or wait until it turns off
automatically after 2 minutes.
Troubleshooting
Please check our website (www.dermlite.com) for
the most current troubleshooting information. If
your DermLite requires servicing, please go to the
"Service & Support" pages at www.dermlite.com,
where you can complete a "Repair Request" form.
Or, contact your local 3Gen dealer.
No Light
Fully recharge the battery and check again. If the
condition persists, your DermLite may require
servicing.
LED Fails
The LEDs used in your DermLite are designed to
last over 100,000 hours. If any one of the LEDs
fails, your DermLite requires servicing.
Mechanical Malfunction
Please contact 3Gen to arrange for service.
Care and Maintenance
Your DL1 is designed for trouble-free operation.
There are no adjustments to be made nor is any
special servicing required. NEVER attempt to open
or modify the device for any reason.
Cleaning and Disinfection
The exterior of your DermLite may be cleaned or
disinfected by wiping it with Isopropyl alcohol (70%
vol.). Do not use alcohol or disinfectants in the opti-
cal areas of the unit. Do not use abrasive material
on any part of the equipment or immerse the device
in liquid. Do not autoclave.
Cleaning the Lens and the Polarizers
The lens and the polarizing filters should be treated
as high quality photographic equipment and should
be cleaned with standard lens cleaning equipment
and protected from harmful chemicals.
DermLite DL1 components include:
Four 3mm white LEDs, three-element lens, cross-
polarized spacer, glass faceplate with 10mm scale,
lithium-polymer battery, USB to Micro-USB cable,
mobile device snap case.
Warranty
5 years for parts and labor.
Serial number and company information are em-
bedded inside the unit.