Estimated assembly time: 20 minutes
Tools Needed
• 5/16" nut driver or wrench
• 7/16" socket/ratchet or wrenches
• #4 Phillips screw driver
All models are furnished with a wheel, mount-
ing hardware and handles. Parts will be found
in shipping carton.
You should have the following assembly parts:
Wheel (1), Axle (1), Rear Cross Support (1),
Legs (2), Rubber Feet (2), Rear Handles (2),
Front Handle (1), Handle Grips (2), Extension
Cord Wraps (2) (see page 24).
Parts are referenced by designated letter
throughout assembly instructions. Hardware
packet provided with heater may contain more
parts than needed for heater assembly. Hard-
ware packet, part number 122094-01, contains
the following (quantity used in parenthesis):
Description
A 5/16" - 18 x 7/8 PPH (4)
B Spacer (2)
C 5/16" - 18 x 1
/
1
D 1/4" - 20 x 2
/
3
4
E 1/4 - 20 Nut (4)
A
B
Wire Guard (Canadian Models)
1. Remove two screws securing front of up-
per shell to lower shell (see Figure 2).
2. Place wire guard on top of upper shell
flange.
3. Insert screws through wire guard and up-
per shell flange. Tighten screws firmly.
Wire Guard Screws
(Canadian models only)
Figure 2 - Attaching Wire Guard
118419-01D
aSSemBly
Part No.
121123-03
113497-02
PPH (2)
121123-04
2
Bolt (4)
HC4-22C
NTC-4C
D
C
E
Upper Shell
Wire
Guard
www.desatech.com
Wheel and Handles
IMPORTANT: Install hardware finger tight only
at this time. After assembly is complete, use
tools to tighten entire assembly
1. Place heater with bottom of tank flat on
floor.
2. Attach rear cross support with two bolts
(A), see Figure 3.
3. Push rubber feet onto each leg (left and
right), see Figure 4.
4. Assemble each leg (left and right) onto
each side of rear cross support. Loosely
secure each side with bolts (A) (see Fig-
ure 5).
Figure 3 - Attaching Rear Cross Support
Figure 4 - Rubber Feet and Legs
Bolt (A)
Leg
Figure 5 - Legs Attached to Rear Cross
Support
Rear
Cross
Support
Bolt (A)
Rear Cross Support
5