Assembly - Whites MX 7 Manual Del Propietário

Fiber Bolt,
Thumbnut &
Non-metallic
Washers

Assembly

1. Remove all parts from the shipping carton and check assembly diagram
to ensure all parts are present.
2. Install black rubber washers on fiber lower rod; attach search coil to
lower fiber rod. Use only the nonmetallic washers, fiber bolt, and fiber
thumbnut provided to secure search coil loop to the lower fiber rod.
3. Insert lower fiber rod into center rod so that the spring buttons line up
with one of the length-adjustment holes in the center rod. Turn the cam-
lock to eliminate any slack.
4. Insert the center extension rod into the hand-grip section. Turn the cam-
lock to eliminate any slack.
5. Wind the search coil cable around the rods, first revolution over the top
of the rod, all the way to the display pod. Plug the cable into the connector
on the back of the display. Tighten the retainer ring securely.
6. Thread the velcro armcup through the slots on the armcup. With your
arm in position, fold the strap over onto the velcro so that the strap is
loose enough to to pull your arm in and out of the armcup.
7. Grip the detector and sweep the search coil over the floor. If the fit feels
Search Coil
Search Coil Cable
Camlock
6
Camlock
Center Rod