Whites MX 7 Manual Del Propietário página 11

DISC
TONE
REJ VOL
VCO ON/
NO VCO
SAT
PRGRAM
IRNGNT
SALTRK
FREQ
LIGHT
INCHES/METRIC
RESET
AUD MOD
Discimina- Using the +/- buttons controls which discrimination zone
tion is being adjusted. Using the pinpoint button will turn the
current discrimination zone on or off. If the zone selection
cursor is left under a particular zone for a couple seconds,
the text will change from "DISC" to a short descriptor of
what kind of targets in that zone, (e.g. GOLD, QUARTR, etc.).
All zones to the left of the cursor can be discriminated
and all others accepted by holding the pinpoint button for
a short time. The disc mask can be cleared by placing the
cursor on the lowest zone and holding the pinpoint button
Tone ID 1
Mode
Reject 10%
Volume
VCO All Turns All Metal audio on or off. Only available in programs
Metal Audio that use All Metal audio.
SAT Control 0
Program Changes the search program- Coin and Jewelry, All Metal,
Beach Prospecting, Hi-Trash and Relic
Iron Grunt OFF
Salt Track OFF
Mode
Frequency -3
Offset
Backlight 0
Strength
Depth Scale Allows the user to select whether to show depth valuels in
inches or centimeters
Factory Allows the user to perform a factory reset, returning all
Reset programs and options to initial factory default settings
Reduces Not available in All Metal Modes
volume
on deeper
targets
20 Central number displays the number
of tones in the selected Tone ID mode.
Avaialble settings are 1, 2, 4, 8 and
20-tone modes. Only in programs with
Discrimination Audio
70% Assigns rejected targets a reduced
volume level. Enhances results in heavy
trash
8 Controls the amount of SAT used in All
Metal modes. Higher SAT values provide
faster target response/recovery; lower
SAT values provide better depth. Only in
programs that use All Metal Audio
ON Turns on or off the Iron Grunt in an All
Metal audio mode. Only available in pro-
grams that use All Metal audio
ON Tuns on or off the ability for the ground
tracking system to track to soil with
large salt content. Used mainly on the
beach or in alkaline soils. This option is
always turned on in the Beach program
7 Adjusts operating frequency. Used for
noise rejection and to allow 2 units to
operate in close proximity
5 Adjusts the strength of the LCD Back-
light. If backlight strength is decreased
to 0, the backlight is off. If the backlight is
later turned on using the Power button,
backlight strength will return to the
default value of 3
11