Idiomas disponibles
Idiomas disponibles
EN
After each 20,000 cycles, or as experience indicates, drain and refill the Impulse Unit
Drive Assembly using the Fluid Replacement Kit (Part No. EQ106S-K400). Lubricate the
hex drive and the output shaft before assembly.
Torque Adjustment
To adjust the torque on these Twin Blade Impulse Wrenches, proceed as follows:
1. Remove the Regulator Cap.
2. Rotate the Drive Shaft until the Torque Adjustment Screw is visible in the opening.
3. Using the supplied pin, rotate the Torque Adjustment Screw clockwise to increase
torque. To decrease torque, rotate the Torque Adjustment Screw counter-clockwise.
4. See appropriate controller manual for torque adjustment when used in conjunction with
a controller.
5. Replace the Regulator Cap.
Make all final adjustments at the job.
Parts and Maintenance
When the life of the tool has expired, it is recommended that the tool be disassembled,
degreased and parts be separated by material so that they can be recycled.
The original language of this manual is English.
Tool repair and maintenance should only be carried out by an authorized Service Center.
Refer all communications to the nearest Ingersoll Rand Office or Distributor.
EN-2
NOTICE
(-)
(+)
80206675_ed2
