2610050572.qxp_GAL12V-20 1/8/18 12:43 PM Page 4
Extension Cords
AN
SHOULD NOT BE USED
UNLESS ABSOLUTELY NECESSARY. Use of
improper extension cord could result in risk of fire
and electrical shock. If an extension cord is used,
make sure:
a. The pins on plug of extension cord are the same
number, size, and shape as those of plug on
charger.
b. The extension cord is properly wired and in
good electrical condition.
1. The charger was designed to fast charge the
battery only when the battery temperature is
between 32˚F (0˚C) and 113˚F (45˚C). If the
battery pack is too hot or too cold, the charger will
not begin charging the battery. (This may happen
if the battery pack is hot from heavy use). Once
the battery temperature returns to its safe
charging temperature, between 32°F (0°C) and
113°F (45°C), the charger will automatically begin
charging.
2. A substantial drop in operating time per charge
may mean that the battery pack is nearing the end
of its life and should be replaced.
3. Remember to unplug charger during storage
period.
4. If battery does not charge properly:
The manufacturer is not responsible for radio
interference
caused
modifications to this equipment.
modifications could void the user's authority to
operate the equipment.
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions:
1) This device may not cause harmful
interference, and
2) This device must accept any interference
received, including interference that may
cause undesired operation.
NOTE! This equipment has been tested and
found to comply with the limits for a Class B
digital devices, pursuant to Part 15 of the FCC
rules. These limits are designed to provide
reasonable
protection
interference in a residential installation. This
equipment generates uses and can radiate radio
4
EXTENSION
CORD
Important Charging Notes
FCC Caution:
by
unauthorized
Such
against
harmful
SAVE THESE INSTRUCTIONS
c. The wire size is large enough for AC ampere
rating of charger as specified below:
d. An extension cord is a temporary solution. Move
the charger to a standard receptacle as soon as
the job has been completed.
Length of
25
Cord, Feet
AWG Size
18
of Cord
a. Check for voltage at outlet by plugging in
some other electrical device.
b. Check to see if outlet is connected to a light
switch which turns power "off" when lights are
turned off.
c. Check battery pack terminals and charger
connectors for dirt. Clean with cotton swab and
alcohol if necessary.
d. If you still do not get proper charging, take
or send tool, battery pack and charger to your
local Bosch Service Center. See "Tools, Electric"
in the Yellow Pages for names and addresses.
Note: Use of chargers or battery packs not sold
by Bosch will void the warranty.
frequency energy and, if not installed and used in
accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference to
radio or television reception, which can be
determined by turning the equipment off and on,
the user is encouraged to try to correct the
interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
50
100
150
16
16
14