Tabla de contenido
Idiomas disponibles
Idiomas disponibles
2610052950.qxp_BC1880 5/1/19 12:52 PM Page 3
storage, attempting any maintenance or
cleaning. Such preventive safety measures
reduce the risk of electric shock or fire.
16. Keep the battery charger clean by blowing
compressed air on charger vents and wiping
the charger housing with a damp cloth.
Battery Care
them away from metal objects. For example,
Battery Disposal
Do not attempt to disas-semble the battery
or remove any component projecting from
the battery terminals. Fire or injury may result.
Prior to disposal, protect exposed terminals
with heavy insulating tape to prevent shorting.
Lithium-ion Batteries
If equipped with a lithium-ion battery, the
battery must be collected, recycled or disposed
of in an environ mentally sound manner.
"The EPA certified RBRC Battery
Recycling Seal on the lithium-ion
(Li-ion) battery indicates Robert
Bosch Tool Corporation is
voluntarily participating in an
Extension Cords
UNLESS ABSOLUTELY NECESSARY. Use
of improper extension cord could result in risk
of fire and electrical shock. If an extension cord
is used, make sure:
a. The pins on plug of extension cord are the
same number, size, and shape as those of plug
on charger.
b. The extension cord is properly wired and in
good electrical condition.
1. The charger was designed to fast charge the
battery only when the battery temperature is
between 32˚F (0˚C) and 113˚F (45˚C). If the
battery pack is too hot or too cold, the charger will
not begin charging the battery. (This may happen
if the battery pack is hot from heavy use). Once
the battery temperature returns to its safe
charging temperature, between 32°F (0°C) and
113°F (45°C), the charger will automatically
begin charging.
2. A substantial drop in operating time per
charge may mean that the battery pack is
nearing the end of its life and should be replaced.
3. Remember to unplug charger during storage
period.
When batteries are not in
tool or charger, keep
AN EXTENSION CORD
SHOULD NOT BE USED
Important Charging Notes
Contamination may result in electric shock or fire.
17. Replace battery pack if a substantial drop
in operating time per charge is observed.
Battery pack may be nearing the end of its life.
to protect terminals from shorting DO NOT
place batteries in a tool box or pocket with nails,
screws, keys, etc. Fire or injury may result.
DO NOT PUT BATTERIES INTO FIRE OR
EXPOSE TO HIGH HEAT. They may explode.
industry program to collect and recycle these
batteries at the end of their useful life, when
taken out of service in the United States or
Canada. The RBRC program provides a
convenient alterative to placing used Li-ion
batteries into the trash or the munici pal waste
stream, which may be illegal in your area.
Please call 1-800-8-BATTERY for information
on Li-ion battery recycling and disposal
bans/restrictions in your area, or return your
batteries to a Skil/Bosch/Dremel Service Center
for recycling. Robert Bosch Tool Corporation's
involvement in this program is part of our
commitment to preserving our environment and
conserving our natural resources."
c. The wire size is large enough for AC ampere
rating of charger as specified below:
d. An extension cord is a temporary solution.
Move the charger to a standard receptacle as
soon as the job has been completed.
Length of
25
Cord, Feet
AWG Size
18
of Cord
4. If battery does not charge properly:
a. Check for voltage at outlet by plugging in
some other electrical device.
b. Check to see if outlet is connected to a
light switch which turns power "off" when lights
are turned off.
c. Check battery pack terminals and charger
connectors for dirt. Clean with cotton swab and
alcohol if necessary.
d. If you still do not get proper charging, take
or send tool, battery pack and charger to your
local Bosch Service Center. See "Tools, Electric"
in the Yellow Pages for names and addresses.
Note: Use of chargers or battery packs not sold
by Bosch will void the warranty.
3-
-
50
100
150
16
16
14
Tabla de contenido
