Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Start-up / Maintenance and Cleaning
Controlling light effects with
the remote control
Note: The transmitter in the remote control
located on the end opposite the battery compart-
ment.
Be sure there are no obstructions between the
transmitter and receiver
The functions are:
button:
LED tape light on
button:
LED tape light off
Selection wheel
Light colour:
Move your finger over the
selection wheel and stop at
the desired light colour or
touch a location to select a
specific light colour.
button:
warm white light
button:
cold white light
/
button:
Brightness adjustment (9 set-
tings): Press the
increase the brightness. Press
the
brightness. The LED tape light
will stop changing when the
minimum or maximum bright-
ness has been reached.
Note: If no buttons are pressed for approx. 10 to
15 seconds, the key lock will automatically
activate. To deactivate, press the
18 GB/IE
is
5
.
4
button to
button to reduce the
button.
Shortening the LED tape light
The LED tape
may be trimmed to size.
6
DANGER TO LIFE BY
ELECTRIC SHOCK! Disconnect the LED tape
from the mains before performing any work. Unplug
the mains adapter
from the socket to do so.
1
Remove the fixing clamp
shown in Fig. F.
Determine the desired length for the LED tape
Important: Be sure to trim the LED tape
at the right point. The cutting point is the exact
middle between the positive and negative
poles and is always marked with a black line.
Cut the LED tape
6
Be sure the cutting point is free from grease
and is dry before attaching the end cap
the LED tape
with the adhesive
6
Fig. G).
Check it is seated correctly and observe the
adhesive curing time of approx. 12 hours.
Mount the LED tape
section „Installing the LED tape (see Fig. A)".
Changing the battery
If the range of the remote control
the battery needs to be replaced.
To do so, slide the battery compartment out of
the remote control
Remove the battery.
Insert the new battery.
Note: The correct polarity is indicated on the
back of the remote control.
Slide the battery compartment back into the
remote control
.
5
Maintenance and Cleaning
DANGER TO LIFE BY ELEC-
TRIC SHOCK! Disconnect the LED tape
the mains before performing any work. Unplug the
mains adapter
from the socket to do so.
1
and screws
7
8
with scissors (see Fig. F).
13
(see
12
as described under
6
is reduced,
5
.
5
from
6
6
as
.
6
6
to
Capítulos
Tabla de contenido
