Connecting Viper Cleaner To Pool; Installing The Universal Wall Fitting - Hayward VIPER 5500 Guia Del Usuario

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Connecting The Viper Cleaner To Pool
Warning – Risk of Injury
The Booster Pump must be OFF when connecting or
disconnecting cleaner or hose.
Caution – Risk of Equipment Damage
The filter pump must always be run to clear air from the
system before turning on the Booster Pump. Never run the
Booster Pump without the main filter pump ON. Running the
Booster Pump dry will damage the Booster Pump and void
its warranty.
Installing Universal Wall Fitting
Specification: Dedicated Return Line in Pool Wall
Depth: approximately 6 inches below water level
Size: 1-1/2 inch NPT Female Threaded
1. Flush plumbing lines before proceeding.
2. Turn Booster Pump and Main Filtration Pump OFF.
3. Remove plug or existing universal wall fitting from
previously installed pool cleaner (if any).
4. Remove the Universal Wall Fitting (Part P, page 4) from
the Wall Quick Connect (Part L, page 4) on the hose.
5. When installing or re-installing the Universal Wall Fitting
use Teflon
®
tape on its plastic threads. Leave at least two
starting threads on the end of the Universal Wall Fitting
un-taped.
6. Screw the Universal Wall Fitting into the Dedicated
Return Line.
Important: Turn Universal Wall Fitting 1 full turn to the
right to engage starting threads. Be sure both parts are
started properly (not cross threaded) then resume
tightening. Do not over tighten.
Connecting Hose to Wall Fitting
1. With the Booster Pump and filtration system turned OFF,
from the pool deck looking down, insert the Wall Quick
Connect into Universal Wall Fitting and turn it to the left
(counter clockwise) to lock.
2. Pull the Wall Quick Connect outward to check that
the Wall Quick Connect is locked into the Universal
Wall Fitting.
3. To disconnect the hose, first turn the Booster Pump OFF
then push the Wall Quick Connect toward the wall, turn it
to the right (clockwise) and pull the Wall Quick Connect
out of the Universal Wall Fitting.
6
Dedicated Line
Universal Wall Fitting
Wall Quick Connect
Universal
Wall Fitting
Wall Quick Connect
®
TEFLON
is a registered trademark of E.I. du Pont de
Nemours and Company.
Use Only Genuine Hayward Replacement Parts.
Dedicated Line

Capítulos

Tabla de contenido

Solución de problemas

loading

Tabla de contenido