Installing Supply Lines To The Condenser Unit (Sp950T Only) - Dometic GROUP WAECO CoolAir RT880 Instrucciones De Instalación

Installation
➤ Lay the connection cable for the battery box in a protected place.
➤ Trim the negative cable (black) to length if necessary and attach an
appropriate ring terminal.
➤ Connect the negative cable (black) directly to the negative terminal of
the battery.
I
NOTE
Place the fuse holder no more than 0.3 m from the positive terminal of
the battery.
➤ Attach the fuse holder in a suitable location.
➤ Lay the positive cable (red) to the fuse holder and trim.
➤ Trim the shorter connection cable from the fuse holder to the correct
length and connect with a joint connector on the positive cable (red).
➤ Insulate the connection cable with the joint connectors properly.
➤ Trim the longer connection cable from the fuse holder if necessary and
fit a suitable ring terminal.
➤ Connect the longer connection cable from the fuse holder with the ring
terminal directly to the positive terminal of the battery.
6.2.6 Installing supply lines to the condenser unit
(SP950T only)
Observe the following instructions when installing the supply lines:
 Also observe the installation instructions for the condenser unit.
 The maximum cable length between the evaporator and condenser
unit is 4.20 m (fig. 6, page 6).
 When installing and bending supply lines, avoid narrow radii. Use a
suitable round object as a bending aid. A radius which is too narrow
will buckle the refrigerant line, and the parking cooler will be inoper-
able.
➤ Shorten any supply line which is not needed by bending a curve.
➤ Apply packing compound (fig. 7 1, page 6) to prevent water entering
between the rear wall of the truck and the clip.
I
NOTE
If you wish to avoid damaging the rear wall of the truck (drilling a hole),
you can also apply the clip using a suitable adhesive. Observe the
instructions provided by the adhesive manufacturer.
44
CoolAir RT880, SP950T
EN