Kenmore 111.22062 Manual De Uso Y Cuidado página 9

2. Remove the upper hinge hole plug (3)
from the top left side of the door and
the upper hinge pin bushing (4) from
the door top right side and swap their
positions.
3. Remove the door stop (5) from the
bottom right side of door and install on
the door bottom left side. Although
there is a hole for the plug side of the
stop, there is only an indentation for the
screw side of the stop. You will have to
apply some force to turn the screw into
the door surface.
4. Lay the appliance on its back. Remove
the leveling feet from the bottom of the
cabinet by turning the feet counter-
clockwise. Use a 10 mm box end or
socket wrench to remove the hinge pin
bolt and washer from the bottom hinge
bracket (6). Also remove the screw and
washer next to the hinge pin bolt from
the bracket. Reinstall the bolt, screw
and washers on the other side of the
hinge bracket.
5. Remove the four hinge bracket bottom
screws and single front screw and
remove hinge bracket from cabinet.
Remove the plug and screw from the
left side of cabinet and insert on right
side. Remove single screw on bottom
left corner and install on bottom right
corner. Use the 5 previously removed
screws to install the hinge bracket on
the left side of the cabinet.
6. Reinstall the leveling feet into cabinet
base. Raise the cabinet to upright
position. Insert the upper hinge pin into
the bushing on top of door. Reinstall
door onto cabinet. Use the 2 previously
removed screws to tighten upper hinge
to its recess in the cabinet top.
NOTE: After the door is reinstalled,
make sure that the top of the door is
level with the top of the cabinet. If the
door is not level, the rubber gasket will
not make a good seal with the cabinet.
Remove cover plate and use the screws
to reattach it to the cabinet right corner.
9