Table 1 Selectable Wattage Tap Settings - Federal Signal Global Serie Instrucciones De Instalación Y Mantenimiento

Installation and Maintenance Instructions
4.
Slide out the PCB until the terminals clear the housing. Strip
the wire insulation 5 mm to 6 mm (0.22 in).
5. The Model G-SPK has five selectable wattage tap settings on
the high power setting and five selectable wattage tap settings
on the low power setting. See Table 1 for options and terminal
block wiring connections. To choose either a high power or
low power tap setting, set the PCB jumper
HIGH POWER
Each terminal block position has in/out connection points.
Terminal 1 Terminal 2
Audio +
Audio +
Audio +
Audio +
Audio +
Audio +
*Connect the ground wire the terminal block position marked
6.
Insert the PCB into the enclosure and fully tighten the PCB
captive screw.
7. Place the cover on the housing and tighten it by turning it
clockwise.
8.
To ensure O-ring compression, the cover must be fully seated
against the housing when the threads are tightened. Turn
the M3 set screw on the side of the housing until the screw
contacts the housing.
16
or
LOW POWER

Table 1 Selectable wattage tap settings

Terminal 3
Audio -
Audio -
Audio +
Audio +
Audio -
Audio -
Audio +
Audio +
Model G-SPK Global Series Loudspeaker
J4
position.
Terminal 4 J4 Setting
Audio -
Audio -
Audio -
Audio -
Audio -
Audio -
to either the
Watts
High 15 W
High 10 W
High 7 W
High 5 W
High 2 W
Low 1 W
Low 0.7 W
Low 0.5 W
Low 0.3 W
Low 0.1 W
.
EARTH