Tools Needed; Wiring The Ex D Models; Figure 10 Ex D In/Out Pcb Connections - Federal Signal Global Serie Instrucciones De Instalación Y Mantenimiento

Tools needed:

• 1.5 mm A/F hexagon key
• No. 1 Phillips screwdriver
• Wire stripper

Wiring the Ex d Models

To wire the Ex d flameproof loudspeaker:
1. Unscrew the M3 hex set screw on the side of the housing one
full turn.
2. Remove the cover from the housing by turning the cover
counter-clockwise. Three 120 degree spaced reliefs are
provided for a 3/8 inch spanner wrench if needed. If the cover
will not unscrew, back out the set screw a few additional turns.
3. Loosen the captive Phillips screw retaining the driver/printed
circuit board (PCB).
Model G-SPK Global Series Loudspeaker
Installation and Maintenance Instructions

Figure 10 Ex d in/out PCB connections

HIGH
POWER
J2
LOW POWER
J4
2W
10W
J1
15W
1
J3
0.1W
0.7W
1W
20000203
HIGH POWER
80hm 80hm 2W
5W 5W
7W
10W
15W 7W EARTH
2 3 4
0.5W 0.3W 0.1W
1W 0.7W 0.3W
0.5W
LOW POWER
15