Troubleshooting - EMOTION BH EVO Manual Usuario

EN
USER MANUAL

TROUBLESHOOTING

Description
System overcurrent
System overcurrent
TMM Sensor
Motor error
Motor sensor error
Battery low
Motor blocked
System overcurrent
Overheating
Protection against overheating
Communication error
Pedal error
Sensor error
Can Communication
System overvoltage
Torque sensor out of range
Over temperature
Below temperature
Current out of range
Torque sensor out of range
Speed sensor signal
Temperature discharging error
22 / 23 / 24
50
25 / 26
Error
01
02
03
04
05
08
09
10
11
12
13
14
15
16
21
22
23
24
25
26
27
28
1/ 2 / 10 / 21
EASYGO / EVO / NITRO / AWD
U S E R M A N U A L
Observations
Check that the connection between the motor and the con
troller is correct. If not, replace the controller.
Replace the controller.
Check that the connection between the TMM sensor and the
controller is correct. Check to see if the output of the TMM
sensor exceeds the normal range, it must be 0.1V-3.5V.
Check the motor or controller connector.
Check that the connection between the motor and the
controller is correct. If the sensor inside the motor is broken,
replace the sensor or motor with a new one. Check that the
connection between the motor cable and the controller is
correct. If not, replace the controller.
Check the battery level or replace it with a new one.
Motor stopped due to accident. Motor off.
If there is a bad contact bad between the controller and the
motor connector, replace it with a new one.
If the temperature exceeds the set value, the current gradually
weakens.
Enters into temperature protection mode, and the controller
stops.
Check the cable and the connector.
Take your foot off the pedal and switch on again.
Readjust the sensor.
Check connection motor and can converter. If error does not
dissappear, contact a BH dealer.
Restart the system. If error does not dissapear, contact a BH dealer.
13 / 16 / 27 / 28
8
EN