Arneg Barcellona Serie Guía De Instalación Y Manejo página 37

• comply with the local standards in force
The installation
• comply with the environmental climatic class 9
area should
• have a floor able to support the weight of the cabinet
• a switch with automatic protection against short circuits, ground discharges
• provide the space required for correct ventilation, use and maintenance
For the cabinet to work properly, the room temperature and relative humidity
Conditions
must not exceed the limits of a climate class 3 (+25°C; R.H. 60%) according to
environmental
the standard EN-ISO 23953 - 2.
Cabinet delivery • make sure the packing is intact and that it does not display readily apparent
• carefully perform the unpacking operation in order not to damage the cabinet;
• check that cabinet components are intact
• should you notice any damage immediately inform the manufacturer
Installation pro-
cedure (Fig.3)
What to avoid
• gently remove the protective film, eliminate glue residues with suitable sol-
First cleaning
• carry out the first cleaning using neutral products, dry with a soft cloth
05060169 00 04-08-2017
and dispersions between the electric power line and the machine;
damages;
Step
carefully examine the installation area, eliminating any danger to the
1
operator;
remove the package only if the cabinet is placed in the opera-
2
tion area
3 lift the cabinet safely
4 use suitable scissors to cut the clip tightening straps-A-
5 remove the clips and the frame
6 lower and place the cabinet in the area of use
7 adjust the horizontal position of the cabinet using a spirit level (Fig.8)
8 check that all feet are into contact with the floor
9 level the cabinet both in front and back
Install maximum 3 cabinets within the same power supply and cooling
line
Should you need to move the cabinet, the latter must be levelled again.
Incorrect levelling
DO NOT install the cabinet (Fig.7):
- in areas at risk of explosion
- in open air and therefore subjected to atmospheric agents;
- near heat sources (direct sunlight, heating systems, incandescence
lamps, etc.)
- in the vicinity of air currents (close to doors, windows, air-condition-
ing systems, etc.) that exceed a speed of 0.2 m/s
vents
DO NOT use alcohol to clean the methacrylate (Plexiglas) parts
DO NOT use abrasives or metal sponges
Action
Barcellona
English
37