Cleaning Your Bike; Worn Parts - Accell group Route Manual De Instrucciones

2 CLEANING YOUR BIKE

After your ride, wash your bike with soapy water (liquid dish soap is recommended for its ability to remove grease
without damaging the bike). Avoid using high-pressure washers if possible. If you have to use one, avoid directing the
stream directly at the joints and bearings (for full-suspension models).
Dry your bike with a soft cloth in order to avoid rust and corrosion. While carefully drying your entire bike, you will also
be able to inspect all the different parts and detect any potential problems.
Before storing your bike in a clean and dry place, lubricate the drivetrain parts with an appropriate product.
You can also take this time to control the brakes, see if the wheels are deformed, and check for any play.

3 WORN PARTS

Always keep an eye on component parts that receive a lot of wear and tear (especially the brakes) in order to avoid any
risks. If you have any doubts, you can check the manual from the component manufacturer or check with your Lapierre
authorized dealer. It's better to prevent than to heal, so never wait until the last minute!
List of consumable parts:
- Braking components (pads, rims)
- Tires, inner tubes, rim strips
- Cables and casing
- Transmission parts (chain, chainwheels, cassette, bottom bracket)
- Shock struts and bushings
- Full suspended frames pivot bearings.
IV - MAINTENANCE
MAINTENANCE - 19