Connecting The B050-000 Or B051-000; Operation; Basic Operation; Keyboard Hotkeys - Tripp-Lite NetCommander AGCB6533 Serie Manual Del Propietário

Installation
Connecting a B050-000 or B051-000 IP Remote Access Unit to the B070-016-19
1. Disconnect the Jumper Cable Console Connectors that are plugged into the KVM
Console Ports.
2. Plug the end of the Jumper Cable you just disconnected into the Local Console Ports of
the IP Remote Access Unit.
3. Plug the PS/2 and VGA connectors from the IP Remote Access Unit into the KVM
Console Ports.
4. For further setup instructions for the B050-000 or B051-000 IP Remote Access Unit refer
to the Owner's Manual that comes with the unit.

Operation

Basic Operation

Switch between the connected computers using any of the following methods:
• The OSD (On Screen Display)
• Keyboard hotkey commands
The OSD is also used to adjust various settings.
A confirmation label at the top of your monitor screen identifies which computer is currently
selected.

Keyboard Hotkeys

To switch to the next computer, press and release the [Shift] key, then press the [+] key.
To switch to the previous computer, press and release the [Shift] key, then press the [-] key.
Note! You can use the [+] key of the alphanumeric section or of the numeric keypad on
a US English keyboard. With a Non-US English keyboard, use the [+] key of the
numeric keypad only.
12-10-052-933244.indb 10
(continued)
Figure 7 Connecting a B050-000 or B051-000 IP Remote Access Unit
10
10/15/2012 2:58:34 PM