Technical Data; Warranty Notice - ANSMANN Powerline 5 Manual De Instrucciones

are inserted to the left or right of the 9V charging slot. Ensure that you insert the 9V
battery in the correct direction for polarity according to the symbols in the charging slot.
The charging indicator (LED) above the 9V charging slot lights red when the battery is
inserted correctly and the START button has been pressed for about 2 seconds. After the
timer for the 9V battery has timed-out, there will be an automatic mains cut off using
Zero Watt Technology (if no round cells are inserted and still charging). If the charger is
used continuously (without the Zero Watt function cut-off being invoked) please remove
the 9V block battery after 20 hours.
disPlaY oF tHe CHarging status For round Cells
Charging: The LED at the appropriate charging slot lights red. On the LCD the battery
icon will be filled up by 4 bars from bottom to top. The 4 bars in the battery
icon will indicate the charging status in 25% steps. Depending on the
battery voltage, the bottom one, two or three bars are permanently on
while the other flashing bars fill up the battery icon.
Ready: The LED at the appropriate charging slot lights green. On the LCD the
battery icon is full and to the left of the battery icon "OK" is indicated. The
fully charged battery is provided with a trickle charge until the charger
disconnects itself automatically from mains.
Error: The LED at the appropriate charging slot flashes red. On the LCD the full
battery icon flashes and to the left of the battery icon "BAD" is indicated.
The charger recognized a defective battery or a non rechargeable battery.
After the automatic disconnection from the mains, all LED and the LCD switch off.
disPlaY oF tHe CHarging status For tHe 9V BloCK
Charging: The LED at the charging slot lights red. On the LCD there is no indication.
After the automatic disconnection from the mains, the LED switches off.
enVironMental CoMMents
Do not dispose the device in the normal household waste. Please return it to your dealer
or to your nearest recycling centre or collection point. Please recycle all packing materi-
als for the sake of the environment. Batteries must not be disposed of in the household
waste. Dispose batteries at a collection point or at an appropriate retail store.
Care & MaintenanCe
To make sure that the charger works properly, please keep the contacts in the charging
slots free from dust or contamination. To clean the unit disconnect it from the mains or
car and use only a dry cloth.

teCHniCal data

Input: 100-240V AC / 50-60Hz
Charging currents: 1000mA / Mignon AA, Baby C, Mono D
500mA / Micro AAA
15mA / 9V Block E
Max. charge capacity: 11000mAh for round cells
280mAh for 9V Block
disClaiMer
Information in these operating instructions can be changed without prior notice.
ANSMANN cannot accept liability for direct, indirect, accidental or other claims or
consequential damages originated by not using this device as indicated by these
operating instructions.

warrantY notiCe

We hereby offer a 3 year warranty on this charger. This does not apply to damages
caused by low-quality batteries leaking inside the charger or non-observance of the
operating instruction or physical damage due to lack of proper care.
Technical details subject to change without prior notice. No liability accepted for typographical errors
or omissions. 09/2010