Tripp-Lite APSX Serie Manual Del Propietário página 8

Mounting
WArnIng! Mount your Inverter/Charger BEFOrE DC battery and AC power
connection. Failure to follow these instructions may lead to personal injury and/
or damage to the Inverter/Charger and connected systems.
Tripp Lite manufactures a variety of different Inverter/Chargers with a variety of different mounting options for use in vehicular or non-vehicular
applications. Tripp Lite recommends permanent mounting of your Inverter/Charger in any of the configurations illustrated below. User must
supply mounting hardware and is responsible for determining if the hardware and mounting surface are suitable to support the weight of the
Inverter/Charger. Contact Tripp Lite if you require further assistance in mounting your Inverter/Charger.
Horizontal Mount
A
Using the measurements from the diagram, install two user-supplied ¼" (6 mm) fasteners
into a rigid horizontal surface, leaving the heads slightly raised.
Charger back over the fasteners to engage the mounting slots molded on the bottom of the
C
Inverter/Charger cabinet.
into the mounting feet molded on the front of the Inverter/Charger cabinet.
The polycarbonate cabinet and mounting feet of your Inverter/Charger are durable enough to allow for wall mounting as well (if your
vehicle compartment requires this configuration). For wall mounting, the control panel of the Inverter/Charger must face to the side and not
up or down.
Allow 2" (50 mm) minimum front and rear clearance for adequate ventilation.
Install and tighten two user-supplied ¼" (6 mm) fasteners
B
Slide the Inverter/
8
C
4.5 in.
(11.4 cm)
B
6.75 in.
(17.1 cm)
6.75 in.
(17.1 cm)
7.87 in.
(20 cm)
A