Through-The-Wall Installations; Top View - Friedrich SS08 Manual De Instalación Y Funcionamiento

Through-the-wall Installations

The following instructions apply to wood, masonry,
brick, concrete or cinder block wall construction
WARNING
Falling Object Hazard
Not following Installation Instructions
for mounting your air conditioner can
result in property damage, injury, or
death.
STEP 1 Follow steps 1, 2, 3 and 4 of the "STANDARD SASH WINDOW
INSTALLATION" instructions beginning on page 10.
Figure A
CABINET
SILL
PLATE
TURN SILL PLATE
END TO END
Figure B EXTRA THICK WLL CONSTRUCTION
MAXIMUM WALL THICKNESS
MODEL
SMALL CHASSIS
MEDIUM CHASSIS
LARGE CHASSIS
BEFORE
SCREW
(2 REQUIRED)
DETAIL 1
NUT
(2 REQUIRED)
RETAINER, CHASSIS
THIS SIDE ONLY
DETAIL 2
BEND TABS DOWN
CONDENSER
AIR INTAKE
LOUVERS
TOP VIEW SHOW ING
A
BEVELED SIDES FOR
AIR INTAKE. WALL
7 "
BELOW UNIT MUST BE
7 "
BEVELED ALSO.
15 "
920-198-01
STEP 2 CABINET PREPARATION – Remove the sill plate from the
c b a n i t e y b
plate. Note that the chassis retainer is secured by a right side
nut and screw (See Detail 1, Figure A.) Bend the tabs of the
sill plate down into its channel at both ends of the plate or cut
them off (See Detail 2, Figure A.) Turn the sill plate end to end,
8 1 ° 0 a d n
so that the head of screw is on bottom of cabinet facing up and
nut is on top facing down (See Detail 3, Figure A.) Insure that
the chassis retainer is reinstalled as shown in the detail.
STEP 3 WALL PREPARATION – The maximum wall thickness permis-
b i s e l t i w o h
to be installed. THE OUTSIDE CABINET CONDENSER-AIR-
N I A T K E L -
INSIDE THE WALL AREA. Observe the maximum wall thickness
h s w o i n t n
SPECIAL INSTRUCTIONS FOR EXTRA THICK WALLS –
F r o s n i l a t i t a l
in the chart, the following suggested construction may apply.
NOTE: HOLES
MOVED TO
BACK SIDE

TOP VIEW

CONDITIONED ROOM SIDE AIR
CONDENSER AIR
OUTLET / REJECTED
HEATED AIR
e r m v o n i t g e h w t o u n s t a d n c s e r
i e r s n a t . l l e R e v s r t e e h o e i r t n i t a n o
t u p s c e l a i o c s n u r t i t c n o s i e d e t m r n i
O U V E R S M U T S N O T B E L B O C K
e h h c r a a t d n i d g a a r m n i i F u g e r . B
n o n i a w s l l x e e c d e n i t g e h m x a m i
AFTER
NUT
(2 REQUIRED)
DETAIL 3
SCREW
(2 REQUIRED)
SCREW AND NUT
ORIENTATION NOW
REVERSED
2" MINIMUM
BOTH SIDES
CONDENSER AIR
INTAKE LOUVERS
NOTE: Condenser air inlets
and outlet must be unobstruct-
ed to avoid the recirculation of
rejected heated air.
s w e r a t n i n i t g e h l l i s
f o u n s t a d n c s e r s w
d e b t y e h m o e d s l e z i
E D B Y E X E T N D N I G
u m t c i h n k s e s s o h n w
15