Fig. 7
AIR CLEANER MAINTENANCE
Replace Oil-Foam element if very dirty or damaged.
➊
• Push cover tab
to release cover, then pull cover
away from engine to service air filter.
• Check and clean the intake chamber for dirt.
➋
• Wash Oil-Foam element
and water. Squeeze dry in a clean cloth. Saturate
Oil-Foam element in engine oil and squeeze in a
clean cloth to remove excess oil.
• Engine will smoke if too much oil is left on filter.
CAUTION
:
Do not use pressurized air or solvents to clean.
Pressurized air can damage filter; solvents will
dissolve filter.
Fig. 8
SPARK PLUG MAINTENANCE
WARNING
DO NOT check for spark with spark
plug removed. Use only Briggs & Strat-
ton Spark Tester, to check for spark. DO
NOT crank engine with spark plug
removed.
• The electrodes on a spark plug must be clean and
sharp to produce the powerful spark required for
ignition. If the spark plug is worn or dirty the harder
it is to start your engine. Replace the spark plug
each season.
• Spark plug gap should be .64 mm or 0.025 in.
KEEP ENGINE CLEAN
Periodically remove grass and chaff build-up from
engine. Clean finger guard.
Do not spray engine with water to clean because water
could contaminate fuel. Clean with a brush or
compressed air.
WARNING
Engine should be kept clean to
reduce risk of overheating and
ignition of accumulated debris.
Clean engine when engine is cold.
GB
STORAGE
The following precautions should be taken if storing
your trimmer unit for a period exceeding 30 days, or for
seasonal storage.
• While engine is still warm, change oil.
• Clean engine of surface debris, chaff or grass.
in liquid detergent
• Drain all fuel from fuel tank into proper receptacle
for storage.
• Press the primer bulb 15 times to purge fuel from
carburetor and fuel lines. Drain remaining fuel into
proper receptacle. If fuel is to be disposed, please
refer to local rules for proper disposal.
• Remove spark plug. Place 1 teaspoon or 5 cc of oil
into spark plug hole.
• Pull starter rope slowly 8-10 times to properly coat
the cylinder bore and piston for storage. Replace
spark plug and tighten. Any residual oil may burn
off in subsequent starts. This may result in white
smoke emission from muffler.
• This trimmer may be stored in a variety of
positions. It is best to store in horizontal position
with the spark plug up. Do not store or transport
with the spark plug down.
Note: Storing or transporting with the spark plug down
will result in hard starting and/or engine smoking.
Store in a clean, dry area. DO NOT store
near a stove, furnace or water heater
which uses a pilot light or any device that
can create a spark.
➋
• When removing the unit from storage, only use
fresh gasoline. Perform operation checks, see
maintenance schedule, before starting engine.
D
DK E
F
GR
I
N
WARNING
4
NL P
S
SF
SERVICE
See an Authorized Briggs & Stratton Service Dealer.
Each one carries a stock of Genuine Briggs &
Stratton Parts and is equipped with special service
tools. Trained mechanics assure expert repair
service on all Briggs & Stratton engines. Only
dealers advertising as "Authorized Briggs &
Stratton" are required to meet Briggs & Stratton
standards.
Partial List of Genuine Briggs & Stratton Parts
Oil
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Synthetic Oil
. . . . . . . . . . . . . . . . . . . . . .
Oil pump kit (uses standard electric drill
to remove oil from engine quickly)
Gas additive
. . . . . . . . . . . . . . . . . . . . . . . . .
Fuel hose assembly
. . . . . . . . . . . . . . . . .
Air filter-foam
. . . . . . . . . . . . . . . . . . . . . .
Resistor spark plug
. . . . . . . . . . . . . . . . . .
Spark tester
. . . . . . . . . . . . . . . . . . . . . . . .
Spark plug wrench
. . . . . . . . . . . .
Repair manual
. . . . . . . . . . . . . . . . . . . . .
To purchase, or view other products Briggs &
Stratton has available, see an Authorized Briggs &
Stratton Service Dealer. Use our web site at
www.briggsandstratton.com
nearest you, or check the "Yellow Pages".
Walking fingers logo and "Yellow Pages" are registered
trademarks in various jurisdictions.
Need Assistance? Go to the website or call,
1-800-233-3723, (U.S.A. and Canada) to hear a
menu of pre-recorded messages offering engine
maintenance information.
100005
100074
. . . . .
5056
5041
696935
696923
696876
19368
89838 -or- 5023
275072
to find a dealer