Engine Oil Replacement - CLIPIC RADAR 125CC Manual Del Usuario

Start engine oil

ENGINE OIL REPLACEMENT

Before engine is fully cooled, engine oil should be drained
away.
1. Disassemble cap of injection oil.
2. Put a basin under engine firstly, then take off oil plug.
3. Press start engine button for five minutes to ensure that
engine oil is drained off completely.
4. Refit oil plug. When installing it, user should pay attention
to 'O' oil sealer that must be intact.
5. Fill in about 1.4L engine oil, start the engine. After engine
working for several minutes, turn it off, check the oil mass
once more. If it doesn't measure up demand, engine oil would
continue to be added.
ATTENTION
If local natural condition is bad, frequency of repla-
cing oil should be shortened properly, please refer
to page 84.
89
4