Whirlpool Operation - Jacuzzi FINESTRA WALK-IN BATH Serie Instrucciones De Instalación Y Funcionamiento

Finestra™ Walk-In Bath
Daily Purge
Each day, the blower will automatically activate a daily purge. The blower will operate for one minute on high power,
followed by 15 seconds at ½ power.
To set purge time:
Wait until the time which you desire the daily purge to activate, with the blower off, press and hold the plus button for
five seconds. To confirm that you have set the time, the blower will cycle between on and off 2 times in a 4 second
span.
To cancel daily purge:
With the blower off, press and hold the plus button for five seconds. To confirm that you have cancelled the purge, the
blower will come on for 1 second and then stop.
YOU MUST SET THE DAILY PURGE UPON INSTALLATION; THE DEFAULT IS NO PRE-SET DAILY PURGE.
If a power failure occurs, the system will default to no daily purge cycle.

Whirlpool Operation

ON: Press the jet button once to turn the whirlpool jets
ON.
The whirlpool motor will be on high speed. The indicator
lights at left will illuminate brightly.
OFF: Press the jet button a second time to turn the
whirlpool jets OFF.
If in chromatherapy lighting mode or blower mode (indicator lights to the left of the jet button are dim), you will
need to press jet button once to resume whirlpool operation mode and then a second time to turn the whirlpool
power off.
Decrease Speed
Press the (-) button to decrease whirlpool speed.
There are 2 whirlpool motor speeds, high and low. The
indicator lights display the setting.
•
1 light on = Low speed
•
4 lights on = High speed
Increase Speed
Press the (+) button to increase whirlpool speed.
There are 2 whirlpool motor speeds, high and low. The
indicator lights display the setting.
•
1 light on = Low speed
•
4 lights on = High speed
Installation and Operation
Low
Low
www.jacuzzi.com
Jet
High
High
Page 17