General Operation Information - Jacuzzi FINESTRA WALK-IN BATH Serie Instrucciones De Instalación Y Funcionamiento

General Operation Information

All bathtubs manufactured by Jacuzzi Luxury Bath are
designed for "fill and drain," which means the bathtub
should be drained after each use and filled with fresh
water by the next bather. This is a health precaution,
as these bathtubs are not designed to hold water
continuously like pools or spas.
Two control panel types are available for the Luxury Bath
series. Refer to details below:
•
J4 Luxury Electronic Control Panel:
Operational instructions for this panel is listed
below.
Please note the following:
For Airbath bathtubs, only the Blower Operation is
applicable.
For Whirlpool bathtubs, only the Whirlpool
Operation is applicable.
For Salon Spa bathtubs, both Blower Operation and
Whirlpool Operation is applicable.
•
Optional J5 Luxury LCD Control Panel:
Operation instructions for this panel are outlined in
the supplemental guide provided in your warranty
pack. Refer to this document for complete operation
details (P/N GU47000).
For Whirlpool and Salon Spa
Combination Bathtubs
Close the drain and fill the bathtub until water is at least
1˝ to 2˝ (25mm to 51mm) above the highest jet (see
water line indicated in the illustration). Do not turn on the
whirlpool system at any time if the jets are not completely
immersed in water. Running the whirlpool system when
there is insufficient water in the bathtub could result
in water spraying outside the bath area. Running the
whirlpool system without sufficient water will damage the
recirculating pump.
Drain the bathtub completely before attempting to
open the door.
When exiting the bathtub, turn off all therapy
operations and drain tub completely before opening
the door.
Page 14
J4 Control Panel - Salon Spa
Main Menu
www.jacuzzi.com
Finestra™ Walk-In Bath
J4 Control Panel - Air Bath
J4 Control Panel - Whirlpool
Jet Air
POWER
J5 Control Panel
Fill to at least 1˝ to 2˝
above highest jet
Installation and Operation