Appendix 5 Set Push Video; A5.1 Prerequisite; A5.2 Enable Push Video; A5.2.1 From Iphone / Ipad - Avtech AVC708H Manual Del Usuario

APPENDIX 5 SET PUSH VIDEO

Note: Available only when your DVR supports Push Video.
This DVR series supports instant event notifications to your iPhone / iPad / Android mobile device with our
self-developed program, "EagleEyes", installed. When a man is detected by a human detection camera or the
external alarm device, the DVR will immediately receive alarm signals and send to your iPhone / iPad / Android
mobile device.
Note: iPhone, iPad and Android are the trademarks or registered trademarks of their respective holders.

A5.1 Prerequisite

Before setting this function, make sure you have checked the following:
 You have an iPhone / iPad / Android mobile device with our self-developed program, "EagleEyes", installed. For details,
please refer to the previous chapter.
 A human detection camera is connected to CH1, or an external alarm device is connected to "PUSH VIDEO Alarm In" on
the rear panel. Make sure a camera is also connected to record for alarm occurrences. To know which video channel
corresponds to which alarm pin, please refer to "APPENDIX 3 PUSH VIDEO CONFIGURATION" at page 65.
 The event record function of your DVR is not disabled.
 The motion detection function of your DVR is not disabled.
 Your DVR is connected to Internet. For details, please refer to
http://www.surveillance-download.com/user/CMS.pdf.

A5.2 Enable Push Video

A5.2.1 From iPhone / iPad

Step1: In the iPhone / iPad main menu, select "Settings"  "Notifications". Select "EagleEyes", and make sure
"Notification Center" is set to "ON".
Step2: Open "EagleEyes", and switch the Push Video button to "ON". You'll receive the message indicating that
Push Video is on.
Step3: Return to the main menu of your iPhone / iPad. You'll receive event notifications when there's a human
detection or alarm event. Select "Launch" to immediately play the recorded clip.
70
APPENDIX 5 SET PUSH VIDEO