Dccs; Ivs - Avtech AVC708H Manual Del Usuario

5.4.8 DCCS

Note: This function is for selected models only.
Note: DCCS is supported only for CH1. Make sure you've connected a DCCS-enabled camera to the
video channel of CH1, and you see "
CAMERA CH1 CH2 CH3 CH4 CH5 CH6 CH7 CH8 CH9 CH10 CH11 
DETECTION
ALERT
NETWORK
DISPLAY
RECORD
DEVICES
DCCS

IVS

NOTIFY
EXIT
1) DIAGNOSTIC
Click "START" to start examining the DCCS signal transmission between the DVR and the camera. The
result will display in "CONNECTION".
2) MENU
Click "SETUP" to configure the connected zoom lens control camera.
Different zoom lens control cameras might have different parameter settings. For details, please refer to their
own user manuals.
Note: While configuring the camera parameters, the DVR will switch to the corresponding channel, and
you can simultaneously preview the effects for the settings.
3) DEVICE
Here shows the model number of the camera.
4) CONNECTION
Here shows the examining result for DCCS signal transmission between the DVR and camera. The
message is as follows:
MESSAGE SHOWN
CHECKING
OK
FAIL
ADVANCED CONFIG
DIAGNOSTIC
MENU
DEVICE
CONNECTION
MEANING
The DVR is checking the DCCS signal transmission between the DVR and camera.
The signal transmission is fine and the DCCS function works properly.
The signal transmission is too weak or not available for the DCCS function to work properly.
" in the channel status bar.

START
SETUP
AVK523
OK
37
MAIN MENU