Brinly DTZ-48BH Manual Del Propietário página 8

================================================================================================
2
Figure 6.
8
Slide the clamp plate (3) over the v-bracket (1)
flanges then slide the 2" spacer (16) and the 1-3/4"
spacer (8) between them.
Make sure that the v-bracket assembly with the 2"
spacer tube (8) fits with clamp arm (2) and the
v-bracket assembly with the 1-3/4" spacer tube (16)
fits with the fixed arm (17).
Insert 3/8" x 3-1/2" hex bolt (7) through all parts
and tighten the 3/8" nylon lock nuts (4) finger tight.
Slide each v-bracket assembly over the ends of the
clamp arm (2) and the fixed arm (17)
Tighten the 3/8" nylon lock nuts down completely.
Slide the fixed arm (17) into the tube with decal (6)
and bolt the two parts together keeping the 3/8"
nylon lock nut finger tight for adjustment later.
Figure 7.
NOTE: Before installing support frame on
ZTR be sure to apply the rubber edging
(42) to each v-bracket. Verify and cut 8
pc approximately 3.0" long. There is 30.0"
of rubber edging (42) provided with the
dethatcher
TWO PEOPLE ARE RECOMMENDED FOR ATTACHING THE MOUNT TO THE ZTR
Pivot clamp arm (2) out as shown to allow it to be easily attached. With a partner hold the mount up to the casters of the tractor and swing the
clamp arm back in so that it interfaces with the cylindrical tube above the wheel of the ZTR. Tighten 3/8" x 4" bolt (12) till the acorn nut
interfaces that dimple plate located on the tube with decal (6). With a 15/16" wrench tighten 3/8" x 4" bolt (12) until mount is firmly attached to
the ZTR, the ideal position of the clamp arm (2) when fully tightened it perpendicular (90°) to the tube with decal (6).
Note:
1) If clamp arm (2) is not perpendicular to tube with decal (6) loosen the 3/8" x 4" bolt (12) and remove mount. Remove 3/8" x 3" bolt (3) and
3/8" nut (4) and move tube with decal in or out over fixed arm mount (17) to readjust depending if you need to fit a smaller or wider frame
respectively.
2) To keep the gap between the back of the mount and the front of the ZTR as small as possible the two "V" brackets (1) can be adjusted by
losening the 3/8" lock nut (12) and sliding the entire assembly back toward the front of the ZTR. Always keep the mount parallel with the front of
the ZTR.
Once adjustments are made ensure that all nuts and bolts are tightened and that the mount is VERY secure to the front of the ZTR.
8. 1009719 Rev E
ASSEMBLY
6
4
2
Approx.
3.0" verify
measurement
cut ends at 45
degrees
OUNT TO THE ZTR
ove the wheel of the ZTR. Tighten 3/8" x 4" bolt (12) till the acorn nut
7
4
17
1
ZTR Mower ZTR Mower
4
12
11
6
With a partner hold the mount up to the casters of the tractor and swing th
7
3/8" x 3-1/2" Hex Bolt
Qty. 5
3
16
1
4
3/8" Nylon Lock Nut
Qty. 5
17
7
1
See
note 2