Tabla de contenido
Idiomas disponibles
Idiomas disponibles
================================================================================================
Figure 2.
25
WARNING:
Failure to install safety wires can result in
personal injury if a tine should dis-engage
from the tine tray.
Figure 3.
28
Hand tighten the fasteners used to bolt
the front mount (20) to frame bracket
(19). Install the wheel (23) to the axle
(22) using 5/8" washers (31) and 5/8"
e-ring (30). Insert the nylon bearing (32)
into the top and bottom holes on the end
of front mount (20) with the flange on the
inside.Hold the wheel hub (33) between
the nylon bearings (20) and slide the
axle (22) through the nylon bearing (32)
and the wheel hub (33). Install set screw
(43) into wheel hub (33) and finish the
assembly by installing the e-ring (30) on
to each end of the axle (22).
NOTE: leave the nuts (28) and the set
screw (43) loose for later adjustment
(see Fig 9 and 10)
Two front mount assemblies (20) and
(19) are required see (Fig 4) for orienta-
tion of each assembly and see also
frame bracket (19) install.
6.
1009719 Rev E
ASSEMBLY
NOTE:
Insert each of the two safety wires (25)
through the coils as shown.
Be sure each end is bent completely over the
straight portion of the safety wire.
24
26
27
31
30
Bend each end of both safety
wires as shown
31
5/8" Washer
19
Qty. 2
20
28
5/16" Hex Nut
Qty. 2
30
32
33
Frame Bracket
(19) Install
43
22
31
23
25
24
5/16" x 1" Carrage Bolt
5/16" Washer
Qty. 2
27
30
5/8" E-Ring
5/16" Lock Washer
Qty. 2
Qty. 2
19
Square
Wheel and Axle
Assembled
26
Qty. 2
Capítulos
Tabla de contenido
