Guided Tour - Am1 Receiver - Samson Airline AX1 El Manual Del Propietario

Samson AirLine
AM1

Guided Tour - AM1 Receiver

1: Multi-color LED - The LED will flash red momentarily when the power is switched on and a
charged battery is in place. It will light continuously red when battery is low and needs to be
replaced. When the AM1 is receiving RF the LED will light green. The LED will appear orange
when any combination of these events cause the LED to light green and red simultaneously.
2: Headphone Output - This 3.5mm headphone level output jack can be used to monitor
audio signal.
3: Audio Output - This 2.5mm jack will accept the supplied 2.5mm to 3.5mm stereo SMM14
cable and send the audio signal to the camera or mixer input (see #5 below to set the
correct output level; see wiring diagram on page 19 for options).
4: Headphone Level Trimpot - Use this to adjust the volume
routed to the Headphone Output.
5: Line/Mic Switch - This switch will set the correct signal level at
the Audio Output jack. Set the switch to Line when connecting
the output to a line level input as on a mixer. Set the switch to
Mic when connecting to Mic level input as on a camera.
(Check your equipment manuals for correct gain structure)
6: Power Switch - Switches the Power on and off. The LED on the
front of the AM1 receiver will light momentarily when
switched on. (see #1 above)
4
OUTPUT