Bottom Mounting
See the following figure.
1
2
3
4
5
6
7
Figure 19 Bottom Mounting
TwisTorr Medium-TMP on-board Controller User Manual / 87-901-050-01
TwisTorr Medium-TMP on-board Controller Installation
Turn the pump upside-down;
Place the three fixing blocks with the through holes toward the
inside, and fix them with the three M6 screws to the pump
bottom;
Place the controller on the plastic ring, with the pump cable toward
the pump body;
Fix the controller to the blocks by means of the three socket head
screws M5;
Turn the pump again;
Plug the line card and connect the pump cable to the pump;
Connect the mating connector with the jumper on the interlock
signal to start the pump.
Technical Information
173/181
17