Programming The Control Unit - V2 NIUBA-24V Manual De Instrucciones

17 - PROGRAMMING THE CONTROL
UNIT
-PrG
The configuration menu
items; the display shows the selected item.
i
By pressing , you will pass to the next item; by pressing
will return to the previous item.
By pressing OK, you can view the current value of selected item
and possibly change it.
FinE
The last menu item ( ) allows storing the carried out changes
and going back to the control unit normal operation.
You must exit from programming mode through this menu item if
you do not want to lose your configuration.
m
WARNING: in case no operation is carried out for more
than one minute, the control unit exits from the
programming mode without saving any of your setups and
changes, which will get lost.
i h
By holding down the or keys, configuration menu items will
FinE
scroll fast, until item is viewed.
In this way, you can quickly reach either the top or bottom of the
list.
PARAMETER VALUE
dir
dX
SX
EnSA
no
Si
t.ASE
0.0" - 5.0"
consists in a list of configurable
h
, you
DESCRIPTION
Direction
Set up the functioning directions.
This parameter must be set up based on the RIGHT or LEFT installation
of the barrier (chapter 5)
Installation on the right (DX)
Installation on the left (SX)
Energy saving function
This function is useful for reducing the energy consumption of the
automation device while in stand-by mode.
If the function is enabled, the control unit will enter ENERGY SAVING
mode under the following conditions:
• 30 seconds after completion of an operational cycle
• 30 seconds after an opening (if automatic closure is not enabled)
• 30 seconds after exiting the programming menu
In ENERGY SAVING mode, power to the accessories, display, flashing lights
and closure electromagnets is deactivated.
ENERGY SAVING mode is exited:
• If an operational cycle is activated
• If one of the menus is accessed
Function deactivated
Function activated
Holding magnet anticipation time
This menu allows regulating the anticipated time with which the holding
magnet is unblocked before the barrier comes set in opening action.
m
ATTENTION: if the holding magnet is not present, set this
parameter to zero.
PLEASE NOTE: The locking electromagnet is connected to the accessory
power supply. Hence, it is essential to deactivate the energy saving
function to use it.
-PrG
- 54 -
FinE
dir
P.APP
DEFAULT MEMO
dX
no
0.0"