Important Parts Of Your 7305 Series Devilbiss Suction Unit; Accessory/Replacement Items; Set-Up; How To Operate Your 7305 Series Devilbiss - DeVilbiss Healthcare 7305 Serie Guía De Instrucciones

IMPORTANT PARTS OF YOUR 7305 SERIES DEVILBISS SUcTION UNIT (Page 2)
Description
1. Bacteria filter (non-sterile)
2. 4" Connection tubing
3. Vacuum gauge
4. Tubing connector
5. Vacuum regulator knob
6. DC power input (on side)
7. Power switch
8. 6' patient tubing
9. 800 cc disposable canister w/lid (float shut off incorporated into lid)
10. 90° connection elbow
Switch mode adapter (not shown)
Internal rechargeable battery (not shown)
Carrying case (not shown)
AccESSORY/REPLAcEMENT ITEMS
The following items can be purchased separately as accessories or replacement items for your 7305 Series DeVilbiss Suction Unit:
Description
6' Patient Tubing
12V DC power cord (1each)
1200 ml Reusable collection bottle (16 each)
800 ml Disposable collection bottle (48 each)
Switch mode AC to DC adapter/charger
12V DC high capacity rechargeable battery (1 each)
Carrying case
Replacement gauge
Bacteria filter (non-sterile) (12 pack)

SET-UP

1. Connect either end of the 4" tubing to the tubing connector then connect the other end to the bacteria filter. Ensure that the clear side of the bacteria filter is toward elbow
and bottle when installing/re-installing. Do not reverse direction of filter.
2. The bacteria filter should then be connected to the 90˚ elbow connection, and the 90˚ connection should be connected to the top of the canister lid where it says
<Vacuum>.
3. The 6' patient tubing should be connected to the canister lid at the outlet labeled <Patient>.
4. Please assure that all connections are secure and without leaks before using.
5. Verify that unit is at desired suction level before beginning patient suction.
HOw TO OPERATE YOUR 7305 SERIES DEVILBISS SUcTION UNIT
Before connecting the unit to the AC adapter or 12V DC cord, make sure that the power switch located on the side of the unit is in the "Off" position. Select power source
desired.
LED Explanations:
L1- Green– External power supplied to unit from AC power source or DC cord. Illuminated when external power is supplied.
L2 - Yellow– Battery is being charged. Light will go out when battery is fully charged. (7305P Series only)
L3 - Red– Low battery. Seek another power source and charge battery as soon as possible when light remains on continuous. (7305P Series only)
AC OPERATION– Plug the small connector of the AC adapter into the DC power input located on the side of the unit. Plug the AC end into a grounded wall-outlet power
source.
NOTE– The power supply may become warm to the touch during charging or running of the unit. This is normal.
12V DC OPERATION– (such as a car lighter receptacle). Plug the small connector of the DC power cord into the DC power input on the side of the unit. Plug the large
connector into the 12V DC power receptacle of the automobile.
BATTERY OPERATION– Verify that your unit has an internal rechargeable battery; factory installed on models 7305P series or provider installed on models 7305D series
(installed as an option). To ensure proper operation from internal battery, fully charge the battery for 10-17 hours as explained in the Battery Charging section. To operate the
unit from an internal rechargeable battery, ensure that no external power sources are plugged into the DC power input on the side of the unit.
Turn the unit "On" using the power switch located on the side of the unit. The power indicator light displayed on the top of the unit will indicate which power source is being
used by staying continuously lit when external power is connected.
EN - 4
Factory equipped on models:
All models
All models -- 8mmID FDA approved Silicone tubing. Use only specified connection tubing for
replacement.
All models
All models
All models
All models
All models
All models --.25"ID x 6' FDA approved PVC tubing with connecting couplers. Use only specified
patient tubing for replacement.
All models
All models
All models
7305P series
7305P series
Part No. Description
6305D-611 Circuit board (7305P series & converted battery units)
7304D-619 Circuit board (7305D series)
7305D-601 High capacity battery conversion kit (battery, 7305P-610 circuit board
& battery tray)
7305D-602 Vacuum gauge test fixture
7305P-613 Hospital grade line cord (120 VAC)
7305P-614 Line cord for US
7305D-606 Line cord for Continental Europe
7305D-607 Filter, 800ml collection bottle, elbow & tubing package
7305D-608 1200ml bottle package
Part No.
7305P-610
7305D-610
7305P-620
7304D-636
099HD-614
6710D-609
7305P-631
7305D-603
7305D-604
A-704