Operating Instructions; Switching On: (Figure 5); Switching Off: (Figure 5); Emergency Off Pushbutton: (Figure 5) - Fein Grit GI1005V6 Serie Manual Del Usario

GI 100 (US).book Seite 11 Dienstag, 17. Februar 2009 1:04 13
GI 100

9. Operating instructions.

Never touch the running grinding belt. Danger of injury.
CAUTION
Always use safety glasses. Also use face or
dust mask if cutting operation is dusty. Eve-
ryday eyeglasses only have impact resistant
lenses, they are NOT safety glasses.
Wear appropriate safety clothing. Wear
leather safety gloves, arm guards, leather
aprons and safety shoes. Wear dust mask
and ear protection.
Wear safety glasses.

9.1 Switching ON: (Figure 5)

Release the emergency OFF pushbutton and
lift it up. Press the "I" button.

9.2 Switching OFF: (Figure 5)

Lift up the emergency OFF pushbutton.
Press the "0" button.
After switching off, the machine runs on
for approx. 50 seconds.

9.3 Emergency OFF pushbutton: (Figure 5)

In emergency situations, press the red emer-
gency OFF pushbutton to switch the
machine off.

9.4 Overload protection.

In case of continuous high load over a longer
period of time, the machine is switched off. After
a cooling-down period of approx. 15 minutes,
the machine is ready for operation again.
Present the workpiece to the abrasive belt below
the horizontal centerline of the contact wheel.
Above the centerline, the workpiece will chatter
and it is diffficult to hold, with the possibility the
work piece could be pulled away.
Always use an upward stroke to present the work
piece to the abrasive belt. This method both
improves the cuting and increases safety by
drawing hands away from the abrasive belt.
en
Fig. 5
Emergency
OFF pushbutton
On/Off switch
11