Tabla de contenido
Idiomas disponibles
Idiomas disponibles
• Do not operate the fixture if it has received a sharp blow, been dropped, or
otherwise damaged in any way.
• The direct plug-in charger is intended to be correctly oriented in a vertical or floor
mount position.
• This fixture MUST ALWAYS BE USED in accordance with all electrical and safety
codes and ordinances, including the most recent National Electric Code (NEC) and
with the Occupational Safety and Health Ace (OSHA) Volume 1 on General Industry
Standards and interpretations.
• DO NOT replace batteries.
• DO NOT dispose of battery in a fire.
• DO NOT short the positive-negative terminals together.
• DO NOT work on this battery pack.
• DO NOT disassemble fixture. The fixture does not have any user serviceable parts.
• This product is not intended to be repaired by service personal in case of failure or
component defect (unit can be thrown away).
• This product must not be disposed of together with domestic waste. This product
has to be disposed of at an authorized place for recycling of electrical and
electronic appliances.
• NEVER operate the light with the clear protective lens removed.
• KEEP AWAY from excessive heat or flame.
• DO NOT look directly into the light.
• This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation. The changes or modifications not expressly
approved by the party responsible for compliance could void the user's authority
to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harm-
ful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Call for customer service and/or missing or damaged parts (800-334-6871)
3
Tabla de contenido
