Ariston ELYOS 25 MC8 Manual Del Usuario página 18

GB
When lifting loads with a crane or hoist, make sure the equipment used
for lifting is stable and effi cient and suitably sized for the movement
and weight of the load itself; place the load correctly in slings, tie ropes
around it to limit any oscillations and lateral movements; lift the load
from a position where there is a full view of all the space covered by the
load during lifting; do not allow people to pass or stop in the vicinity of
the suspended load.
Do not direct the air fl ow towards valuable articles, plants or animals.
Install the device on a solid wall that is not subject to vibrations.
Place the condensation drainpipe in such a way as to ensure the correct
fl ow of water towards places where it cannot disturb or damage people,
things or animals.
When drilling the wall, take care not to damage any electrical wiring or
existing piping.
Perform all electrical connections using suitably-sized conductors.
Use electrical equipment suitable for the intended use (in particular,
make sure that the power supply cable and plug are intact and that the
parts featuring rotary or reciprocating motion are fastened correctly);
use this equipment correctly; make sure no equipment could fall from a
height. Disconnect it and put it safely back in place after use.
Protect the device and all areas in the vicinity of the work area using
suitable material.
Move the appliance with the necessary care.
Organise the dislocation of all debris and equipment in such a way as
to make movement easy and safe, avoiding any piles that could yield or
collapse.
Reset all safety and control functions affected by any work performed
on the device and make sure that they operate correctly before restart-
ing the device.
The appliance must be installed in full compliance with national system regulations.
If the power supply cable is damaged, it must be replaced by the manufacturer or
by its technical assistance service, or at least by a suitably qualifi ed individual,
in order to prevent all hazards.
The installation must be carried out by professionally qualifi ed staff, in possession of the skills as required by law
During the installation process, the refrigerator should be connected fi rst, followed by the electricity supply.
In the event of replacement, proceed in the reverse order.
The air conditioning unit must be earthed completely to avoid electric shocks. Do not connect the earthing line to anti-
lightning systems, water or gas pipes, earthing line of the telephone system.
Do not install the air conditioning unit near heat sources or fl ammable material.
The air conditioning unit must be earthed completely to avoid electric shocks. Do not connect the earthing line to anti-
lightning systems, water or gas pipes, earthing line of the telephone system.
Do not install the air conditioning unit near heat sources or fl ammable material.
Symbol legend:
Failure to comply with this warning implies the risk of injury to persons, which in some circumstances may be fatal.
Failure to comply with this warning implies the risk of damage, in some circumstances serious, to property, plants or animals.
18
Personal injury from objects falling from
a height. Damage to the appliance or sur-
rounding objects due to the appliance fall-
ing from a height, knocks.
Damage or perishing due to excessive cold/
heat, humidity, ventilation.
Noise during operation.
Damage to objects due to dripping water.
Damage to existing plants. Flooding due to
water leaking from damaged pipes.
Fire caused by overheating due to electrical
current passing through undersized cables.
Damage to the appliance or surrounding
objects from falling splinters, knocks and
incisions.
Damage to the device or surrounding ob-
jects caused by fl ying splinters, knocks and
incisions.
Damage to the device or surrounding ob-
jects caused by shocks, knocks, incisions
and crushing.
Damage to the device or surrounding ob-
jects caused by shocks, knocks, incisions
and crushing.
Damage or shutdown of the device caused
by out-of-control operation.