Tabla de contenido
Idiomas disponibles
Idiomas disponibles
IMPORTANT! BE SURE CONCRETE HAS BEEN
ALLOWED TO CURE FOR AT LEAST 2 DAYS.
13. Attach post Ears (#30) to holes near the bottom of top
post (#3) using two hex bolts (#25) four washers (#18)
two lock nuts (#4)
and two plastic nut caps (#10)
See Figure 6 & Detail 2.
13
14
15
21
20
16
20
ASSEMBLY INSTRUCTIONS (Day 3)
.
POST EARS LOCATED AT
THE BACK OF THE POLE.
1
3
Figure 7
14. Slide actuator sleeve (#15) over actuator (#16) and place
19
Note: If necessary, use a rubber mallet to tap in
15.
10
4
actuator cap (#13) on top. Slide pivot tube (#14) through hole
near top of both the Steel Actuator &
until equal amounts stick out through both sides of actuator.
See Figure 7.
Pivot Tube (#14)
Slide tab on actuator (#16) between post Ears (#30) and
Secure using one bolt (#19), two washers (#20) and one
lock nut(#21). See Figure 7. This is a pivot point, tighten bolt
but do not over tighten.
16. Place pole cap (#1) onto top of top pole (#3).
Note: Pole cap may be pre-installed by the factory.
8
SAFETY STOP BAR IS LOCATED
AT THE BACK OF THE POLE.
Figure 6
3
18
18
25
30
30
Detail 2
Plastic
3
12
2
Actuator Sleeve
Tabla de contenido
