Tabla de contenido
Idiomas disponibles
Idiomas disponibles
4 18
9
5
22. Slide actuator handle (#35) onto shaft on the bottom of
Actuator (#16). Line up hole in shaft with hole in actuator
handle and insert Pin (#34) to secure. See Figure 11.
23. To aid in the assembly of the backboard, lower the backboard,
by turning the actuator handle, until the lower arm makes
contact with stop bar behind the top pole.
6
18
22
3
Figure 10
20. Attach upper arms (#6) to top pole (#3), as shown
in
Figure 10, using a bolt (#22), two flat washers (#18),
two plastic washers (#5) and one lock nut (#4).
Note: Tighten bolts snug but, do not over tighten. Board
Arms must pivot freely.
21.
If tube plugs (#9) are not already installed insert them into
open ends of the upper board arm (#6). It may be
necessary to use a rubber mallet to tap plugs in.
Figure 11
10
Note: Both upper board arms (#6)
must be positioned with "Inside-
Front" stickers facing each other as
shown.
15
16
35
34
Tabla de contenido
