Tabla de contenido
Idiomas disponibles
Idiomas disponibles
26.
Mount goal assembly (#28) and rim pad (#27) to
backboard, as shown in Figure 13, using four bolts
(#41), four washers (#26), and four locknuts (#4).
tighten fasteners finger tight, leave them loose
enough to level rim.
27. Place a level across rim assembly and adjust rim until
it is level. Finish tightening the four nuts.
Figure 13
41
41
NEVER USE RIM WITH COVERPLATE REMOVED!
28. Attach rim cover plate (#32) using two screws (#33). See
Figure 13.
29. Check all nuts and bolts and make sure everything is
tightened properly. DO NOT over tighten pivot points,
snug is tight enough.
30.
Use the backboard pads (#37) and (#38) as a template and
mark the hole locations on the backboard frame. See Figure
13 and Detail A.
38
33
28
32
40
12
29
(Pre-Installed)
27
42
Detail A
Note: Safety glasses required for Step 31.
31. Drill 9/64" pilot holes into steel backboard frame. See
Detail A. Do not drill through both sides of tube.
Note: Cordless drill recommended for screw installation.
Do not over tighten screws causing screws to strip.
Note: To install screws, it will be easier if you use a
cordless drill with 5/16" socket (instead of Phillips head.)
32. Secure backboard pads (#37) and (#38), as shown, using
screws (#42). Note: Tighten screws tight but, do not over
tighten.
26
4
37
42
Pad #37 & #38
Screw #42
Tabla de contenido
