Installing The Controller; Preparing The Case; Mounting The Controller; Wiring - SOMFY FX24 Manual De Instalación

INSTALLING THE CONTROLLER

Preparing the case

• Remove the cover
Important: Do not remove the electronic circuit board.
• Drill out the mounting holes taking care not to damage the circuit board.
• Use the controller case as the pattern for marking the mounting points on the gate post.
• Drill the gate post.
• Insert the cables and cut them to length.
The electric power line should:
• be reserved exclusively for use by the gate opener,
• have a minimum cross section of 1.5 mm
• be provided with a protection device (10A fuse or circuit breaker) and a residual current device (30 mA),
• be fi tted with an omnipolar disconnection mechanism,
• be installed in line with applicable safety standards.

Mounting the controller

Mount the FX24 on the gate post under the motor drive unit.

Wiring

CONNECTING PERIPHERAL ACCESSORIES

Automatic blinking 24V orange light

Copyright © 2008 Somfy SAS. All rights reserved.
,
2
5